* * * Free Ground Freight on Orders Over $99.00 in the Lower 48 States * * * Excluding: transmissions, crossmembers, fluids, aluminum pans, tools

 Search by categories
 Filter parts by type
classi1-728x800
1965_Mustang_GT_Fastback_front_side_2Untitled-67d1a121f65fc254f7f5aaf0c082e2844AOD Throttle Valve Cable AdjustmentAOD Throttle Valve Cable Adjustments

“1965 to 1973 Mustang AOD Conversion Kit from C4 or C6” | AOD Transmission Information

$ 575.00

Carburator ? *

Speedometer Driven Gear Needed ? *

Motor ? *

Year ? *

Tire Height ? *

Rear End Ratio ? *

Speedometer Drive Gear Needed ? *

SKU: 1965 to 1973 Mustang AOD Conversion Kit Categories: , , , Tags: , , ,

Deluxe AOD Installation Kit for 1965 to 1973 Mustangs from C4 or C6

AOD Throttle Valve Cable Information

 #K65M. You get the AOD to early Mustang crossmember, Lokar throttle valve cable, correct speedometer driven gear, correct flywheel, dip stick, shift lever kit, carburetor adapter for Holley or Edelbrock, transmission mount, block plate, inspection plate and four torque converter nuts.

You can add to or remove from this kit as needed. An AOD with a 10 1/4″ tail housing is only 1/4″ longer than an early Mustang C4 therefore you should be able to reuse your old driveshaft and yoke. The only upgrades to this kit would be a SFI flexplate, cast aluminum pan, speedometer housing parts, wiring harness and oil. The $4.00 per gallon gas will feel like $2.80 per gallon gas with an overdrive conversion.

HPIM1320.JPG (45227 bytes)

Other parts you may need for your conversion.

 

Notice the Holley adapter on the carburetor and the helper return spring on the throttle valve bottom lever. On a stock AOD the correct pressure adjustment usually is minimum throttle valve cable pull at minimum throttle opening (idle) and on an AOD with a Shift Kit installed the correct setting usually is full cable pull at full throttle. If you have a Holley or Edelbrock you must have an adapter installed.

Main Menu